基于故障演化-测试相关性可测性建模方法

Tan Xiao-dong; Luo Jian-lu; Li Qing; Lu Bing; Qiu Jing

doi:10.1631/FITEE.1500011

Your Location：

Home >

Browse articles >

基于故障演化-测试相关性可测性建模方法

计算机与自动化 | Updated：2022-06-06

- 基于故障演化-测试相关性可测性建模方法
- Fault evolution-test dependency modeling for mechanical systems*
- 信息与电子工程前沿（英文） 2015年16卷第10期页码：848-857
- Affiliations：
  
  1.Department of Electronic Technology, Officers College of PAP, Chengdu 610213, China
  2.Science and Technology on Integrated Logistics Support Laboratory, National University of Defense Technology, Changsha 410073, China
- Author bio：
  
  †E-mail:xdt1010@126.com
- Funds：
  
  *Project supported by the National Natural Science Foundation of China (No. 61403408)
- DOI：10.1631/FITEE.1500011
  中图分类号：
- 收稿：2015-01-09，
  
  修回：2015-09-09，
  
  录用：2015-06-15，
  
  纸质出版：2015-10
- Accepted：
Scan QR Code
基于故障演化-测试相关性可测性建模方法[J]. 信息与电子工程前沿（英文）, 2015,16(10):848-857.

Tan Xiao-dong, Luo Jian-lu, Li Qing, et al. Fault evolution-test dependency modeling for mechanical systems*[J]. Frontiers of Information Technology & Electronic Engineering, 2015, 16(10): 848-857.
基于故障演化-测试相关性可测性建模方法[J]. 信息与电子工程前沿（英文）, 2015,16(10):848-857. DOI： 10.1631/FITEE.1500011.

Tan Xiao-dong, Luo Jian-lu, Li Qing, et al. Fault evolution-test dependency modeling for mechanical systems*[J]. Frontiers of Information Technology & Electronic Engineering, 2015, 16(10): 848-857. DOI： 10.1631/FITEE.1500011.

摘要

目的

建立系统中典型故障演化过程中的相关参数与系统中测试节点的关联关系。分析系统对故障的检测、隔离，对故障演化过程跟踪和对故障预测能力的可测性水平，进而指导系统的可测性设计。

创新点

通过故障-征兆、征兆-测试矩阵描述系统故障演化与测试的相关性关系。结合测试节点的灵敏度、检测时间、检测概率等固有属性，建立量化测试对故障演化过程跟踪能力的指标，在故障检测率、故障隔离率等指标基础上，提出故障可跟踪率和故障可预测率的可测性指标。

方法

首先，分析系统中典型故障的演化机理，建立定量描述故障与表征其严重程度的征兆参数的相关性矩阵。其次，使用能量流图分析方法，建立征兆参数与系统中测试节点间的能量传递关系，进而获得征兆参数与测试间的动力学关系。再次，构建衡量系统对故障可检测、可隔离、可跟踪和预测的可测性指标体系，并提出相应的可测性指标预计方法。最后，以某离心泵系统为案例，对本文所提理论的有效性进行验证。

结论

基于故障演化-测试相关性可测性建模方法能定性地描述系统中故障与表征其严重程度的征兆参数间的关系，并能从定量的角度建立各个征兆参数与系统中测试节点的关系。故障可跟踪率和故障可预测率能较好地描述系统中固有测试节点对故障跟踪和预测的水平，以此为基础提出的可测性预计方法能有效预计系统对故障的检测、隔离、跟踪和预测水平，预计结果能有效指导系统的可测性设计。论文的相关理论和方法对于提高系统对故障的跟踪和对故障的预测的可测性水平具有指导意义。

Abstract

Tracking the process of fault growth in mechanical systems using a range of tests is important to avoid catastrophic failures. So

it is necessary to study the design for testability (DFT). In this paper

to improve the testability performance of mechanical systems for tracking fault growth

a fault evolution-test dependency model (FETDM) is proposed to implement DFT. A testability analysis method that considers fault trackability and predictability is developed to quantify the testability performance of mechanical systems. Results from experiments on a centrifugal pump show that the proposed FETDM and testability analysis method can provide guidance to engineers to improve the testability level of mechanical systems.

关键词

Keywords

references

A Alabakhshizadeh , Y Iskandarani , G Hovland , 等 . Analysis, modeling and simulation of mechatronic systems using the Bond Graph method . Model Identif Contr , 2011 . 32 ( 1 ): 35 - 45 . DOI: 10.4173/mic.2011.1.3 http://doi.org/10.4173/mic.2011.1.3 .

G Biswas , S Mahadevan . A hierarchical model-based approach to systems health management . 2007 . Proc. IEEE Aerospace Conf . 1 - 14 . DOI: 10.1109/AERO.2007.352943 http://doi.org/10.1109/AERO.2007.352943 .

CS Byington , M Watson , D Edwards , 等 . A model-based approach to prognostics and health management for flight control actuators . 2004 . Proc. IEEE Aerospace Conf . 3551 - 3562 . DOI: 10.1109/AERO.2004.1368172 http://doi.org/10.1109/AERO.2004.1368172 .

S Deb , KR Pattipati , V Raghavan , 等 . Multi-signal flow graphs: a novel approach for system testability analysis and fault diagnosis . IEEE Aerosp Electron Syst Mag , 1995 . 10 ( 5 ): 14 - 25 . DOI: 10.1109/62.373993 http://doi.org/10.1109/62.373993 .

YC Gao , YX Feng , JR Tan . Multi-principle preventive maintenance: a design-oriented scheduling study for mechanical systems . J Zhejiang Univ-Sci A (Appl Phys & Eng) , 2014 . 15 ( 11 ): 862 - 872 . DOI: 10.1631/jzus.A1400102 http://doi.org/10.1631/jzus.A1400102 .

A Hess , JS Stecki , SD Rudov-Clark . The maintenance aware design environment: development of an aerospace PHM software tool . 2008 . Proc. Conf. on Prognostics and Health Management . 1 - 9 . .

J Johnson . Fault Propagation Timing Analysis to Aid in the Selection of Sensors for Health Management Systems. MS T , 2008 . University of Missouri-Rolla, USA , .

C Kallesøe . Fault Detection and Isolation in Centrifugal Pumps. PhD T , 2005 . Aalborg University, Denmark , .

T Kurtoglu , IY Tumer . A graph-based fault identification and propagation framework for functional design of complex system . J Mech Des , 2008 . 130 ( 5 ): 051401.1 - 0514018 . DOI: 10.1115/1.2885181 http://doi.org/10.1115/1.2885181 .

C Lin , L Hayes , A Malais , 等 . A new dependency model based testability analyzer . 1998 . Proc. IEEE Systems Readiness Technology Conf . 187 - 191 . DOI: 10.1109/AUTEST.1998.713442 http://doi.org/10.1109/AUTEST.1998.713442 .

KR Pattipati , V Raghavan , M Shakeri , 等 . TEAMS: testability engineering and maintenance system . 1994 . Proc. American Control Conf . 1989 - 1995 . DOI: 10.1109/ACC.1994.752424 http://doi.org/10.1109/ACC.1994.752424 .

JW Sheppard . Maintaining diagnostic truth with information flow models . 1996 . Proc. IEEE Conf. Record Test Technology and Commercialization . 447 - 454 . DOI: 10.1109/AUTEST.1996.547773 http://doi.org/10.1109/AUTEST.1996.547773 .

WR Simpson , HS Balaban . The ARINC research system testability and maintenance program (STAMP) . 1982 . Proc. IEEE AUTOTESTCON Conf . 88 - 95 . .

WR Simpson , JW Sheppard , CR Unkle . POINTER—an intelligent maintenance aid . 1989 . Proc. IEEE Automatic Testing Conf . 26 - 31 . DOI: 10.1109/AUTEST.1989.81094 http://doi.org/10.1109/AUTEST.1989.81094 .

RB Stone , KL Wood . Development of a functional basis for design . J Mech Des , 2000 . 122 ( 4 ): 359 - 370 . DOI: 10.1115/1.1289637 http://doi.org/10.1115/1.1289637 .

XD Tan , J Qiu , GJ Liu , 等 . A novel approach of testability modeling and analysis for PHM systems based on failure evolution mechanism . Chin J Aeronaut , 2013 . 26 ( 3 ): 766 - 776 . DOI: 10.1016/j.cja.2013.04.044 http://doi.org/10.1016/j.cja.2013.04.044 .

SM Yang , J Qiu , GJ Liu . Hierarchical model-based approach to testability modeling and analysis for PHM of aerospace systems . J Aerosp Eng , 2014 . 27 ( 1 ): 131 - 139 . DOI: 10.1061/(ASCE)AS.1943-5525.0000203 http://doi.org/10.1061/(ASCE)AS.1943-5525.0000203 .

GF Zhang . Optimum Sensor Localization/Selection in a Diagnostic/Prognostic Architecture. PhD T , 2005 . Georgia Institute of Technology, USA , .

浏览量

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

暂无数据