驱动脉冲边沿调制技术及其CPLD实现

Chen Xiao; Qu Dong-chang; Guo Yong; Chen Guo-zhu

doi:10.1631/FITEE.1500111

Your Location：

Home >

Browse articles >

驱动脉冲边沿调制技术及其CPLD实现

电子工程 | Updated：2022-06-06

- 驱动脉冲边沿调制技术及其CPLD实现
- A driving pulse edge modulation technique and its complex programming logic devices implementation*
- 信息与电子工程前沿（英文） 2015年16卷第12期页码：1088-1098
- Affiliations：
  
  1.Electrical Engineering Department, Zhejiang University, Hangzhou 310027, China
  2.School of Automation and Electrical Engineering, Zhejiang University of Science and Technology, Hangzhou 310023, China
- Author bio：
  
  E-mail:andrer007@163.comqudongchang3939@163.comrinatoon@163.comgzchen@zju.edu.cn
  ‡Corresponding Author
- Funds：
  
  *Project supported by the National Natural Science Foundation of China (No. 51177147) and the Zhejiang Key Science and Technology Innovation Group Program, China (No. 2010R50021)
- DOI：10.1631/FITEE.1500111
  中图分类号：
- 收稿：2015-04-07，
  
  修回：2015-11-06，
  
  录用：2015-06-25，
  
  纸质出版：2015-12
- Accepted：
Scan QR Code
驱动脉冲边沿调制技术及其CPLD实现[J]. 信息与电子工程前沿（英文）, 2015,16(12):1088-1098.

Chen Xiao, Qu Dong-chang, Guo Yong, et al. A driving pulse edge modulation technique and its complex programming logic devices implementation*[J]. Frontiers of Information Technology & Electronic Engineering, 2015, 16(12): 1088-1098.
驱动脉冲边沿调制技术及其CPLD实现[J]. 信息与电子工程前沿（英文）, 2015,16(12):1088-1098. DOI： 10.1631/FITEE.1500111.

Chen Xiao, Qu Dong-chang, Guo Yong, et al. A driving pulse edge modulation technique and its complex programming logic devices implementation*[J]. Frontiers of Information Technology & Electronic Engineering, 2015, 16(12): 1088-1098. DOI： 10.1631/FITEE.1500111.

摘要

目的

针对随功率半导体器件开关速度和功率等级的不断提高而产生的严峻的开关电压尖峰问题，以IGBT为对象，提出一种驱动脉冲边沿调制技术，实现对门极驱动电压边沿斜率的调节，抑制IGBT的电压尖峰。

创新点

利用面积等效原理，将门极驱动脉冲信号的边沿映射成一簇脉冲序列，门极驱动电压的上升或下降段即为这些脉冲信号响应的叠加。通过调节脉冲序列的密度和脉冲宽度，调节门极驱动电压边沿斜率，从而调节开关速度限制开关电压尖峰。

方法

将传统的门极驱动信号的边沿映射成一簇脉冲序列，将PWM信号转换为MPWM信号，则脉冲边沿的调制也即为调制该脉冲序列的密度和脉冲宽度，有双向脉冲序列调制BPTM和单向脉冲序列调制UPTM两种方法。对于BPTM调试，MPWM信号为正表示正的驱动电压

被接入，MPWM信号为负则表示负的驱动电压

off

被接入。在IGBT开通时期，若驱动电路的响应能力有限，这种调试方法下门极驱动电压的边沿呈现明显锯齿状，使得门极电压在IGBT导通阈值电压

附近波动，引起IGBT的伪导通，故而可改进为UPTM方法。对于UPTM调制，当调试上升沿时，高电平信号表示接入正的驱动电压

，低电平信号表示不接入驱动电压从而保持门极电压为当前值；当调试下降沿时，高电平信号表示接入负的驱动电压

off

，低电平信号表示不接入驱动电压从而保持门极电压为当前值。文中图9是采用CPLD的具体驱动电路，在BPTM模式下，MOSFET1管和MOSFET2管交替开通和关断，以调制驱动脉冲边沿；在UPTM模式下，只有一个MOSFET管开通和关断来调制驱动脉冲边沿，而另一个MOSFET管被封锁。

结论

采用驱动脉冲边沿调制技术（双向脉冲序列调制BPTM和单向脉冲序列调制UPTM），可以明显抑制开关尖峰。由于基于数字技术，且只需要一个数字芯片，不需要改变硬件电路结构，可通过软件来实现对驱动脉冲边沿的调控，使其适用于不同工况，具有较强的通用性和灵活性。其中，采用单向脉冲序列调制（UPTM）可以解决IGBT伪导通问题，该调制技术对驱动电路响应速度要求不高的特点使其更便于应用。

Abstract

With the continual increase in switching speed and rating of power semiconductors

the switching voltage spike becomes a serious problem. This paper describes a new technique of driving pulse edge modulation for insulated gate bipolar transistors (IGBTs). By modulating the density and width of the pulse trains

without regulating the hardware circuit

the slope of the gate driving voltage is controlled to change the switching speed. This technique is used in the driving circuit based on complex programmable logic devices (CPLDs)

and the switching voltage spike of IGBTs can be restrained through software

which is easier and more flexible to adjust. Experimental results demonstrate the effectiveness and practicability of the proposed method.

关键词

Keywords

references

F Blaabjerg , JK Pedersen . An optimum drive and clamp circuit design with controlled switching for a snubberless PWM-VSI-IGBT inverter leg . 1992 . Proc. 23rd Annual IEEE Power Electronics Specialists Conf . 289 - 297 . DOI: 10.1109/PESC.1992.254660 http://doi.org/10.1109/PESC.1992.254660 .

D Bortis , P Steiner , J Biela , 等 . Double-stage gate drive circuit for parallel connected IGBT modules . IEEE Trans Dielect Electr Insul , 2009 . 16 ( 4 ): 1020 - 1027 . DOI: 10.1109/TDEI.2009.5211849 http://doi.org/10.1109/TDEI.2009.5211849 .

AT Bryant , Y Wang , SJ Finney , 等 . Numerical optimization of an active voltage controller for high-power IGBT converters . IEEE Trans Power Electron , 2007 . 22 ( 2 ): 374 - 383 . DOI: 10.1109/TPEL.2006.889895 http://doi.org/10.1109/TPEL.2006.889895 .

LH Chen , FZ Peng . Closed-loop gate drive for high power IGBTs . 2009 . Proc. 24th Annual IEEE Applied Power Electronics Conf. and Exposition . 1331 - 1337 . DOI: 10.1109/APEC.2009.4802837 http://doi.org/10.1109/APEC.2009.4802837 .

LH Chen , FZ Peng . Active fault protection for high power IGBTs . 2009 . Proc. 24th Annual IEEE Applied Power Electronics Conf. and Exposition . 2050 - 2054 . DOI: 10.1109/APEC.2009.4802956 http://doi.org/10.1109/APEC.2009.4802956 .

L Dulau , S Pontarollo , A Boimond , 等 . A new gate driver integrated circuit for IGBT devices with advanced protections . IEEE Trans Power Electron , 2006 . 21 ( 1 ): 38 - 44 . DOI: 10.1109/TPEL.2005.861115 http://doi.org/10.1109/TPEL.2005.861115 .

HG Eckel , L Sack . Optimization of the turn-off performance of IGBT at overcurrent and short-circuit current . 1993 . Proc. 5th European Conf. on Power Electronics and Applications . 317 - 322 . .

PJ Grbovic . Gate driver with feed forward control of turn off performances of an IGBT in short circuit conditions . 2007 . Proc. European Conf. on Power Electronics and Applications . 1 - 10 . DOI: 10.1109/EPE.2007.4417506 http://doi.org/10.1109/EPE.2007.4417506 .

R Hemmer , P Kviz , M Wendt . IPS Drivers Combine Highest Performance and Design Flexibility . 2010 . Bodo’s Power Systems . 46 - 47 . .

M Hornkamp . 2006 .

N Idir , R Bausiere , JJ Franchaud . Active gate voltage control of turn-on d i /d t and turn-off d v /d t in insulated gate transistors . IEEE Trans Power Electron , 2006 . 21 ( 4 ): 849 - 855 . DOI: 10.1109/TPEL.2007.876895 http://doi.org/10.1109/TPEL.2007.876895 .

JH Kim , DH Park , JB Kim , 等 . An active gate drive circuit for high power inverter system to reduce turn-off spike voltage of IGBT . 2007 . Proc. 7th Int. Conf. on Power Electronics . 127 - 131 . DOI: 10.1109/ICPE.2007.4692362 http://doi.org/10.1109/ICPE.2007.4692362 .

H Kuhn , T Koneke , A Mertens . Considerations for a digital gate unit in high power applications . 2008 . IEEE Power Electronics Specialists Conf . 2784 - 2790 . DOI: 10.1109/PESC.2008.4592367 http://doi.org/10.1109/PESC.2008.4592367 .

L Michel , X Boucher , A Cheriti , 等 . FPGA implementation of an optimal IGBT gate driver based on Posicast control . IEEE Trans Power Electron , 2013 . 28 ( 5 ): 2569 - 2575 . DOI: 10.1109/TPEL.2012.2207463 http://doi.org/10.1109/TPEL.2012.2207463 .

PR Palmer , HS Rajamani . Active voltage control of IGBTs for high power applications . IEEE Trans Power Electron , 2004 . 19 ( 4 ): 894 - 901 . DOI: 10.1109/TPEL.2004.830078 http://doi.org/10.1109/TPEL.2004.830078 .

G Schmitt , R Kennel , J Holtz . Voltage gradient limitation of IGBTS by optimised gate-current profiles . 2008 . Proc. IEEE Power Electronics Specialists Conf . 3592 - 3596 . DOI: 10.1109/PESC.2008.4592512 http://doi.org/10.1109/PESC.2008.4592512 .

ZQ Wang , XJ Shi , LM Tolbert , 等 . Switching performance improvement of IGBT modules using an active gate driver . 2013 . Proc. 28th Annual IEEE Applied Power Electronics Conf. and Exposition . 1266 - 1273 . DOI: 10.1109/APEC.2013.6520462 http://doi.org/10.1109/APEC.2013.6520462 .

ZQ Wang , XJ Shi , LM Tolbert , 等 . A fast overcurrent protection scheme for IGBT modules through dynamic fault current evaluation . 2013 . Proc. 28th Annual IEEE Applied Power Electronics Conf. and Exposition . 577 - 583 . DOI: 10.1109/APEC.2013.6520268 http://doi.org/10.1109/APEC.2013.6520268 .

ZQ Wang , XJ Shi , LM Tolbert , 等 . A d i /d t feedback-based active gate driver for smart switching and fast overcurrent protection of IGBT modules . IEEE Trans Power Electron , 2014 . 29 ( 7 ): 3720 - 3732 . DOI: 10.1109/TPEL.2013.2278794 http://doi.org/10.1109/TPEL.2013.2278794 .

浏览量

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

暂无数据